FX-22-Stack-Moderator-Section-1
FX Wildcat .22 Stackable Moderator Section 1
The FX Wildcat .22 ships without the base section (section 1) or end cap (section 6) of the moderator. If you are installing a new moderator by sections you will need to have section 1 the base section. To this you can add the baffle sections and finally the end cap (section 6).
To reduce the report making your air rifle back yard friendly you need to add the middle components (baffles) to your .22 caliber Wildcat and the end cap (section 6).
Note this moderator is made for and fits only the FX Wildcat.
 |
 |
 |
 |
| Straight Shooters Pellet Sampler .177 | FX .22 Caliber Wildcat Magazine | FX-22-Stack-Moderator-Baffle | FX-22-Stack-Moderator-Section-6 |
|
$25.00
|
$42.00
|
$26.00
|
$26.00
|
There have been no reviews
Recently viewed
Exceptional service and great advice lead me to Craig and this pellet. The tins come with one foam liner in the lid and the one I have shot through had no deformed pellets in it. I am not at a level of measuring and weighing pellets at this point, however, I do single load into the breech and each pellet has the same feel and none have been over tight or the opposite – loose. Each engages the rifling and inserts with the same predictable mannerisms. I have had some JSB’s in the past that varied so much within the same tin that I felt like I should have received several different tins. The results on target were as expected. The results with these Air Arms pellets have been tremendous from my TM 1000. Every pellet going were I aim each time I pull the trigger. I have not been disappointed by the quality control and it is obvious to me that they are sorted well at the factory before going into the tin. Nice tight groups and consistent FT performance. Equally at home on paper or on the...
Jul 10, 2017
